When processing any product, we have certain technical requirements for processing, not casually can be processed, the operator needs to comply with the above requirements, the same is true of automated parts processing. So what are the technical requirements for automated parts processing?

The use of sealing fillers or sealants is allowed when assembling a hydraulic system, but it should be prevented from entering the system.

Parts and components that enter the assembly must have a qualified certificate from the inspection department before they can be assembled.

3, the unstated shape tolerance should meet the requirements of GB1184-80, the uninjected length size allowed deviation ± 0. 5Mm.

For fasteners that are required to tighten the torque, torque wrenches must be used and the tightening moment tightened as specified.

5, before the assembly of strict inspection and removal of parts of the remaining sharp angles, burrs and foreign matter. Make sure the seal is not abraded when loaded.

The parts must be cleaned and cleaned before assembly. There must be no burrs, flying edges, oxidized skin, Rust, chips, oil, colorants and dust.

After the outer ring of the bearing is assembled, the end surface of the bearing cover at the positioning end shall be in contact with uniform, and the surface of the part shall not be defective on the surface of the damaged part such as scratches and abrasions.