Around us, there are a lot of precision parts processing in Dongguan, in the industry, the use of more or less, because of the many, it is necessary to use it in all kinds of processing to process. What about the fully automatic knife system for precision parts processing?

Fine parts processing is to complete a variety of processes in the automatic state of CNC equipment, mainly about a number of fixed large quantities of consumer operations. But about the mold industry and small quantities of consumer units must not be easily on the processing center, many manufacturers buy the processing center when CNC milling to use.

Using the knife bank is very simple for the cost of the CNC system, but the spindle and the knife bank, air compressor, and various knife handles will increase the cost, and the programming and adjustment of the knife bank will also cost a corresponding time. Therefore, the consumption of the same type of less than one or two hundred workpieces as far as possible do not use the processing center, high cost, low efficiency.

Fine parts processing can use a fully automatic knife system, knife mounted, a button, automatic machine tool, direct processing, error in 0.001 ~. Within 0003 mm, it is not much slower than automatic exchange time. If it is a fine part processing center, but there is no automatic knife installation machine tool and no knife library, but there is an automatic knife installation machine tool, the efficiency of the latter in the theory is much higher than the former.

Regarding the domestic manufacturing industry, especially the mold consumer enterprises, are generally single consumption, and the labor resources are sufficient. Therefore, with regard to the processing of small batch industrial parts, we must fully consider the value of the application of funds, and do not use processing center equipment. What is more, there are still many problems in the knife warehouse of domestic manufacturers.