Hardware is a hot industry in this society now, and hardware processing is to make its quality more perfect, so do you want to know what the hardware processing steps are? Let's find out.

First, all employees before entering the job, to check whether their clothing meets the requirements of the job. Do not wear slippers, high heels and safety-related clothing. Wear a hard hat with long hair. Stay in the right posture at work. Have enough spirit to cope with the work. If you find out that you are not feeling well, you must immediately leave the work position and report to the leader. The operation must be concentrated, strictly prohibit small talk, and cooperate with each other. The operator must not operate in an irritable and tired state to avoid accidents and ensure the safety of the operation.

Before the mechanical work, check whether the motor part is lubricated, and then start and check whether the clutch and brake are normal, and empty the machine tool for 1-3 minutes. When the machine is malfunctioning, it is strictly forbidden to operate.

Third, when the mold is replaced, the power is first turned off. After the punching machine movement department stops running, the mold can be installed and debugged. After the installation adjustment is completed, use the hand to move the flywheel to test twice to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are solid, and whether the pressure RIM is in a reasonable position.

Fourth, you must wait for all other personnel to leave the mechanical work area and take away the debris on the workbench before you can start the power supply to start the machine.

After the machine is started, it is operated by one person to carry the material and machinery. Others must not press the electric power building or step on the foot switch board, let alone put the hand into the mechanical work area or touch the moving part of the machine with the hand. When mechanical work, it is forbidden to extend your hand into the sliding block work area, and it is forbidden to use your hand to take and place the workpiece. Tools that meet the standards must be used to take and place artifacts in the punching die. If the machine is found to have abnormal sound or machine failure, the power switch should be turned off immediately for inspection.

6, after work, should turn off the power supply, and arrange the finished products, side materials and miscellaneous items on the job to ensure that the work environment is clean and safe.

However, we must remember that the operating rules must be consciously followed. Do not violate the rules and regulations. If there is a failure, it should cooperate with the maintenance personnel to overhaul. If an accident occurs, immediately cut off the power supply and keep the on-site report to the factory for processing. All the consequences caused by the violation of the operating rules will be borne by the parties. All consequences.