With the continuous improvement of current science and technology, our technicians can know that we have a lot of processing products around us, or processing technology, hardware parts processing is the same, then the precision of precision hardware parts Why will it get worse?

1, the machining accuracy of the parts themselves is poor. Generally speaking, if the time of the device is not adjusted properly, the dynamic error between the axes, or because the shaft drive chain changes due to wear, will affect the accuracy of the parts. In general, the accuracy of the error incurred by this type of error can be re-adjusted to compensate the amount of treatment. If the error is too large, if there is an alarm, it is necessary to stop checking the servo motor and see if its speed can be too high.

2, machine tools in operation will also affect the accuracy of the processing, may be due to the short acceleration and deceleration time, the appropriate extension of the change time, of course, it is also most likely due to the screw and servo motor link loose.

3, due to the extremely poor roundness resulting from the two-axis linkage, the machinery is not adjusted to form the axial deformation of the circle, the shaft gap compensation is not correct or the axis positioning attack offset may have an impact on the precision of the fine parts.